hts(1) [debian man page]
HTS(1) General Commands Manual HTS(1) NAME
hts - httptunnel server SYNOPSIS
hts [options] [host:][port] DESCRIPTION
This manual page briefly documents the hts command. hts listens for incoming httptunnel connections at PORT (default port is 8888), and optionally binds to ip address HOST. When a connection is made, I/O is redirected to the destination specified by the --device or --forward-port switch. OPTIONS
The program follows the usual GNU command line syntax, with long options starting with two dashes (`-'). A summary of options are included below. -h, --help Show summary of options. -c, --content-length BYTES use HTTP PUT requests of BYTES size (k, M, and G postfixes recognized) -d, --device DEVICE use DEVICE for input and output -F, --forward-port HOST:PORT connect to PORT at HOST and use it for input and output -k, --keep-alive SECONDS send keepalive bytes every SECONDS seconds (default is 5) -M, --max-connection-age SEC maximum time a connection will stay open is SEC seconds (default is 300) -s, --stdin-stdout use stdin/stdout for communication (implies --no-daemon) -S, --strict-content-length always write Content-Length bytes in requests -V, --version output version information and exit -w, --no-daemon don't fork into the background -p, --pid-file LOCATION write a PID file to LOCATION AUTHOR
This manual page was contributed by Teemu Hukkanen <tjhukkan@iki.fi>, and was originally written for the Debian GNU/Linux system. HTS(1)
Check Out this Related Man Page
TRACE-CMD-LISTEN(1) TRACE-CMD-LISTEN(1) NAME
trace-cmd-listen - listen for incoming connection to record tracing. SYNOPSIS
trace-cmd listen -p port [OPTIONS] DESCRIPTION
The trace-cmd(1) listen sets up a port to listen to waiting for connections from other hosts that run trace-cmd-record(1) with the -N option. When a connection is made, and the remote host sends data, it will create a file called trace.HOST:PORT.dat. Where HOST is the name of the remote host, and PORT is the port that the remote host used to connect with. OPTIONS
-p port This option will specify the port to listen to. -D This options causes trace-cmd listen to go into a daemon mode and run in the background. -d dir This option specifies a directory to write the data files into. -o filename This option overrides the default trace in the trace.HOST:PORT.dat that is created when a remote host connects. -l filename This option writes the output messages to a log file instead of standard output. SEE ALSO
trace-cmd(1), trace-cmd-record(1), trace-cmd-report(1), trace-cmd-start(1), trace-cmd-stop(1), trace-cmd-extract(1), trace-cmd-reset(1), trace-cmd-split(1), trace-cmd-list(1) AUTHOR
Written by Steven Rostedt, <rostedt@goodmis.org[1]> RESOURCES
git://git.kernel.org/pub/scm/linux/kernel/git/rostedt/trace-cmd.git COPYING
Copyright (C) 2010 Red Hat, Inc. Free use of this software is granted under the terms of the GNU Public License (GPL). NOTES
1. rostedt@goodmis.org mailto:rostedt@goodmis.org 06/11/2014 TRACE-CMD-LISTEN(1)