IBUS(1)IBUS(1)NAME
ibus - Intelligent Input Bus for Linux / Unix OS
DESCRIPTION
IBus is an Intelligent Input Bus. It is a new input framework for Linux OS. It provides full featured and user friendly input method user
interface. It also may help developers to develop input method easily.
Homepage: http://code.google.com/p/ibus/
NOTES
if you are using gdm or kdm, run the following command, then restart your gdm or kdm.
$ im-config
SEE ALSO ibus-daemon(1), ibus-setup(1), ibus-config(1), scim(1), fcitx(1)
2008-11-08 IBUS(1)
Check Out this Related Man Page
mdc(4) Kernel Interfaces Manual mdc(4)Name
mdc - DS5100 serial line driver
Syntax
device mdc0 at ibus? vector mdcintr
device mdc1 at ibus? vector mdcintr
device mdc2 at ibus? vector mdcintr
Description
A DS5100 base system (mdc0) provides four asynchronous ports. An optional asynchronous card (mdc1 and mdc2 ) can be added to supply eight
additional ports.
The mdc ports are used as follows:
Port Usage Connector
0 Console port 6-pin MMJ on CPU board
1 Local terminal 6-pin MMJ on CPU board
2 Full modem control port 25-pin D-Sub on CPU board
3 Local terminal 6-pin MMJ on CPU board
An optional asynchronous board provides an additional eight lines:
4 Local terminal 6-pin MMJ
5 Local terminal 6-pin MMJ
6 Full modem control port 25-pin D-Sub
7 Local terminal 6-pin MMJ
8 Local terminal 6-pin MMJ
9 Local terminal 6-pin MMJ
10 Local terminal 6-pin MMJ
11 Local terminal 6-pin MMJ
The console baud rate is set to 9600 baud by default. You can change this by setting the baud environment variable from console prompt.
Each communication port from the serial line controller behaves as described in the reference page and can be set to run at any of 16
speeds. For the encoding, see
You can establish the state of port 2 (port 6) by specifying either modem or nomodem as part of the file entry.
Restrictions
The speed default is to 9600 baud on the console port. The console device must be set for 8-bit character length with one stop bit and no
parity. The driver enforces these restrictions; that is, changing speeds with the command may not always work on console ports.
Files
Console terminal
Full modem control or local terminal
See Alsoconsole(4), devio(4), tty(4), ttys(5), MAKEDEV(8)
RISC mdc(4)
I am running into a small issue and not sure how to fix it or where to even look at this point. I have a shell script on a a box called bluezebra. On this box I have a very small shell script.
#!/bin/ksh
ssh bluemarron "/lcl/apps/Tivoli/netcool/omnibus/bin/TESTING/TEST.sh" &
This script... (0 Replies)