rhino(8) [debian man page]

RHINO(8)							    NUT Manual								  RHINO(8)

NAME

       rhino - Driver for Brazilian Microsol RHINO UPS equipment

NOTE

       This man page only documents the hardware-specific features of the rhino driver. For information about the core driver, see nutupsdrv(8).

SUPPORTED HARDWARE

       This driver has been tested with :

       o   Rhino 6000 VA

       o   Rhino 7500 VA

       o   Rhino 10000 VA

       o   Rhino 20000 VA

       All Rhino models are sinusoidal on-line.

EXTRA ARGUMENTS

       This driver support the following extra optional settings in ups.conf(5):

       battext = n - (default = 0, no extra battery, where n = Ampere*hour )

COMMANDS

       o   load.on - Turn on the load immediately

       o   load.off - Turn off the load immediately

       o   bypass.start - Put the UPS in bypass mode

       o   bypass.stop - Put the UPS out of bypass mode

       o   shutdown.stayoff - Shut down in 3 minutes and do not return

AUTHOR

       Silvino B. Magalhaes <sbm2yk@gmail.com>

SEE ALSO

   The core driver:
       nutupsdrv(8)

   Internet resources:
       The NUT (Network UPS Tools) home page: http://www.networkupstools.org/

Network UPS Tools						    05/21/2012								  RHINO(8)

LIEBERT(8)							    NUT Manual								LIEBERT(8)

NAME

       liebert - Driver for Liebert contact-closure UPS equipment

NOTE

       This man page only documents the hardware-specific features of the liebert driver. For information about the core driver, see nutupsdrv(8).

SUPPORTED HARDWARE

       This driver supports some Liebert UPS equipment with a contact-closure interface. This includes the UPStation GXT2 with their
       contact-closure cable. The smart mode ("Multilink") cable is not supported by this driver.

EXTRA ARGUMENTS

       This driver does not support any extra settings in the ups.conf(5).

BUGS

       This driver does not yet support shutdowns by raising DTR. Be aware that shutdowns are not possible with the stock contact-closure cable.
       You may have to build another cable with DTR connected through to the UPS for it to work.

       There is no way for this driver to detect the hardware or cable. It will start up successfully even if no UPS is present. This is a
       fundamental limitation of any contact-closure driver.

SEE ALSO

   The core driver:
       nutupsdrv(8)

   Internet resources:
       The NUT (Network UPS Tools) home page: http://www.networkupstools.org/

Network UPS Tools						    05/21/2012								LIEBERT(8)