PDCIDE(4) BSD Kernel Interfaces Manual PDCIDE(4)NAME
pdcide -- Promise IDE disk controllers driver
SYNOPSIS
pdcide* at pci? dev ? function ? flags 0x0000
DESCRIPTION
The pdcide driver supports the Promise Ultra33, Ultra66, Ultra100, Ultra100TX2, Ultra100TX2v2, Ultra133, Ultra133TX2, Ultra133TX2v2, Fast-
trak133 and Serial ATA/150 IDE controllers, and provides the interface with the hardware for the ata(4) driver.
The 0x0002 flag forces the pdcide driver to disable DMA on chipsets for which DMA would normally be enabled. This can be used as a debugging
aid, or to work around problems where the IDE controller is wired up to the system incorrectly.
SEE ALSO ata(4), atapi(4), intro(4), pci(4), pciide(4), wd(4), wdc(4)BUGS
The timings used for the PIO and DMA modes for controllers listed above are for a PCI bus running at 30 or 33 MHz. This driver may not work
properly on overclocked systems.
The pdcide driver does NOT function correctly on NetBSD/sparc64.
BSD December 23, 2003 BSD
Check Out this Related Man Page
CMDIDE(4) BSD Kernel Interfaces Manual CMDIDE(4)NAME
cmdide -- CMD Technology and Silicon Image IDE disk controllers driver
SYNOPSIS
cmdide* at pci? dev ? function ? flags 0x0000
options PCIIDE_CMD064x_DISABLE
options PCIIDE_CMD0646U_ENABLEUDMA
DESCRIPTION
The cmdide driver supports the CMD Technology PCI0640, PCI0643, PCI0646, PCI0648, PCI0649, and Silicon Image 0680 IDE controllers, and pro-
vides the interface with the hardware for the ata(4) driver.
The 0x0002 flag forces the cmdide driver to disable DMA on chipsets for which DMA would normally be enabled. This can be used as a debugging
aid, or to work around problems where the IDE controller is wired up to the system incorrectly.
SEE ALSO ata(4), atapi(4), intro(4), pci(4), pciide(4), wd(4), wdc(4)BUGS
There's no way to reliably know if a PCI064x controller is enabled or not. If the driver finds a PCI064x, it will assume it is enabled
unless the PCIIDE_CMD064x_DISABLE option is specified in the kernel config file. This will be a problem only if the controller has been dis-
abled in the BIOS and another controller has been installed and uses the ISA legacy I/O ports and interrupts.
The PCI0646U controller is known to be buggy with Ultra-DMA transfers, so Ultra-DMA is disabled by default for this controller. To enable
Ultra-DMA, use the PCIIDE_CMD0646U_ENABLEUDMA option. Ultra-DMA can eventually be disabled on a per-drive basis with config flags, see
wd(4).
The timings used for the PIO and DMA modes for controllers listed above are for a PCI bus running at 30 or 33 MHz. This driver may not work
properly on overclocked systems.
BSD December 13, 2003 BSD
I am looking for and IDE or at least a compiler that can handle
calls from ADA to C++, including classes and whatnot. I am talking about the AIX platform (RS6000). I have tried Rational's ApexDuo but it sucks. Does anyone know a better solution ?
Pure C++ compilers that are better than IBM's... (0 Replies)
hi,
I am unable to install unix open server 5.0.2 on desktop P-III,750 MHz,20GB HDD (IDE) 1.44 MB FDD, ATAPI IDE 48X cd rom. I prepared 5 boot floppies i.e. boot(N00), AHSBTLD(01), IPXSPX(01),NUC(01), NUC(02). The system was booted with boot(N00) floppy. After booting it asked to identify... (3 Replies)
I would like to build a new box that has the disk mirrored to another IDE disk on a different channel. Does anyone know if a RAID controller like the Promise is supported under RedHat 8, or should I use a software RAID. (1 Reply)
Rebooting with command: boot
Boot device: /pci@1e,600000/pci@0/pci@a/pci@0/pci@8/scsi@1/disk@0,0:a File and args:
SunOS Release 5.10 Version Generic_147440-01 64-bit
Copyright (c) 1983, 2011, Oracle and/or its affiliates. All rights reserved.
WARNING: system call missing from bind file... (8 Replies)
Hi,
I need an IDE for my C application based on AIX 5.3
is there any IDE that I could use directly in AIX or I have to use X window server to visualise it on windows?
Thanks in advance
Hasnaa (3 Replies)