Linux and UNIX Man Pages

Linux & Unix Commands - Search Man Pages

sys_attrs_alt(5) [osf1 man page]

sys_attrs_alt(5)						File Formats Manual						  sys_attrs_alt(5)

NAME
sys_attrs_alt - alt subsystem attributes DESCRIPTION
This reference page lists and describes attributes for the alt (alt) kernel subsystem. This subsystem is used by the Gigabit Ethernet adapters. Refer to the sys_attrs(5) reference page for an introduction to the topic of kernel subsystem attributes. The version number of the alt driver. This is a read-only attribute, and cannot be changed. The version number of the firmware that is downloaded to the Gigabit Ethernet adapter. This is a read-only attribute and cannot be changed. SEE ALSO
sys_attrs(5) sys_attrs_alt(5)

Check Out this Related Man Page

sys_attrs_bparm(5)						File Formats Manual						sys_attrs_bparm(5)

NAME
sys_attrs_bparm - bparm subsystem attributes DESCRIPTION
This reference page lists and describes attributes for the Boot Parameters (bparm) kernel subsystem. Refer to the sys_attrs(5) reference page for an introduction to the topic of kernel subsystem attributes. Identifies the device from which the system was last booted. This attribute corresponds to the console firmware environment vari- able with the same name. Do not modify this value, which is set when the system boots. A combination of flags that controls the boot loader and kernel. This attribute corresponds to the console firmware environment variable with the same name. Values for the variable are: Boot to multiuser mode. By default, the kernel boots to single-user mode. Enable the kdebug debugger to debug the kernel. By default, kdebug is not enabled in the kernel. Produce full dumps when the system crashes. By default, partial dumps are produced. Prompt for an alternate kernel and special arguments when the system is booted. By default, no questions are asked. Set boot_osflags only at the console prompt or by using the consvar utility. Identifies the boot device to be used when one is not included in the boot command line. This attribute corresponds to the console firmware environment variable with the same name. Set bootdef_dev only at the console prompt or by using the consvar utility. SEE ALSO
Commands: consvar(8) Others: sys_attrs(5) System Administration sys_attrs_bparm(5)
Man Page

We Also Found This Discussion For You

1. What is on Your Mind?

Throw my Toys out of the Pram!

Hi Folks, Today hasn't been the best one of my career in IT. I've been a contractor for a major utility company for a number of years, on a number of seperate IT contracts mostly Unix. The company had 10 different flavours of unix and multiple different varsions of most of them. At the... (3 Replies)
Discussion started by: gull04
3 Replies