SIGEMPTYSET(3P) POSIX Programmer's Manual SIGEMPTYSET(3P)
PROLOG
This manual page is part of the POSIX Programmer's Manual. The Linux implementation of this interface may differ (consult the correspond-
ing Linux manual page for details of Linux behavior), or the interface may not be implemented on Linux.
NAME
sigemptyset -- initialize and empty a signal set
SYNOPSIS
#include <signal.h>
int sigemptyset(sigset_t *set);
DESCRIPTION
The sigemptyset() function initializes the signal set pointed to by set, such that all signals defined in POSIX.1-2008 are excluded.
RETURN VALUE
Upon successful completion, sigemptyset() shall return 0; otherwise, it shall return -1 and set errno to indicate the error.
ERRORS
No errors are defined.
The following sections are informative.
EXAMPLES
None.
APPLICATION USAGE
None.
RATIONALE
The implementation of the sigemptyset() (or sigfillset()) function could quite trivially clear (or set) all the bits in the signal set.
Alternatively, it would be reasonable to initialize part of the structure, such as a version field, to permit binary-compatibility between
releases where the size of the set varies. For such reasons, either sigemptyset() or sigfillset() must be called prior to any other use of
the signal set, even if such use is read-only (for example, as an argument to sigpending()). This function is not intended for dynamic
allocation.
The sigfillset() and sigemptyset() functions require that the resulting signal set include (or exclude) all the signals defined in this
volume of POSIX.1-2008. Although it is outside the scope of this volume of POSIX.1-2008 to place this requirement on signals that are
implemented as extensions, it is recommended that implementation-defined signals also be affected by these functions. However, there may be
a good reason for a particular signal not to be affected. For example, blocking or ignoring an implementation-defined signal may have unde-
sirable side-effects, whereas the default action for that signal is harmless. In such a case, it would be preferable for such a signal to
be excluded from the signal set returned by sigfillset().
In early proposals there was no distinction between invalid and unsupported signals (the names of optional signals that were not supported
by an implementation were not defined by that implementation). The [EINVAL] error was thus specified as a required error for invalid sig-
nals. With that distinction, it is not necessary to require implementations of these functions to determine whether an optional signal is
actually supported, as that could have a significant performance impact for little value. The error could have been required for invalid
signals and optional for unsupported signals, but this seemed unnecessarily complex. Thus, the error is optional in both cases.
FUTURE DIRECTIONS
None.
SEE ALSO
Section 2.4, Signal Concepts, pthread_sigmask(), sigaction(), sigaddset(), sigdelset(), sigfillset(), sigismember(), sigpending(), sigsus-
pend()
The Base Definitions volume of POSIX.1-2008, <signal.h>
COPYRIGHT
Portions of this text are reprinted and reproduced in electronic form from IEEE Std 1003.1, 2013 Edition, Standard for Information Technol-
ogy -- Portable Operating System Interface (POSIX), The Open Group Base Specifications Issue 7, Copyright (C) 2013 by the Institute of
Electrical and Electronics Engineers, Inc and The Open Group. (This is POSIX.1-2008 with the 2013 Technical Corrigendum 1 applied.) In the
event of any discrepancy between this version and the original IEEE and The Open Group Standard, the original IEEE and The Open Group Stan-
dard is the referee document. The original Standard can be obtained online at http://www.unix.org/online.html .
Any typographical or formatting errors that appear in this page are most likely to have been introduced during the conversion of the source
files to man page format. To report such errors, see https://www.kernel.org/doc/man-pages/reporting_bugs.html .
IEEE
/The Open Group 2013 SIGEMPTYSET(3P)