dev_addr_add(9) [suse man page]

DEV_ADDR_ADD(9) 					      Network device support						   DEV_ADDR_ADD(9)

NAME

       dev_addr_add - Add a device address

SYNOPSIS

       int dev_addr_add(struct net_device * dev, unsigned char * addr, unsigned char addr_type);

ARGUMENTS

       dev
	   device

       addr
	   address to add

       addr_type
	   address type

DESCRIPTION

       Add a device address to the device or increase the reference count if it already exists.

       The caller must hold the rtnl_mutex.

COPYRIGHT

Kernel Hackers Manual 2.6.					     July 2010							   DEV_ADDR_ADD(9)

eeprog(8)						       System Administration							 eeprog(8)

NAME

       eeprog - reads and writes 24Cxx EEPROMs connected to I2C serial bus.

SYNOPSIS

       eeprog [-fqxdh] [-16|-8] [-r addr[:count]|-w addr] <device> <i2c-addr>

DESCRIPTION

       eeprog uses the SMBus protocol used by most of the recent chipsets.

NOTE

       Don't forget to load your i2c chipset and the i2c-dev drivers.

       The following environment variables could be set instead of the command line arguments:

	   EEPROG_DEV		   device
	   EEPROG_I2C_ADDR	   i2c-addr

PARAMETERS

       Address modes

       -8     Use 8bit address mode for 24c0x...24C16 [default]

       -16    Use 16bit address mode for 24c32...24C256

       Actions

       -r addr[:count]
	      Read count (1 if omitted) bytes from addr and print them to the standard output

       -w addr
	      Write input (stdin) at address addr of the EEPROM

       -h     Print this help

       Options

       -x     Set hex output mode

       -d     Dummy mode, display what *would* have been done

       -f     Disable warnings and don't ask confirmation

       -q     Quiet mode

       Bus

       device Device file representing the I2C bus (eg. /dev/i2c-0)

       i2c-addr
	      I2C bus address of the EEPROM (eg. 0x3A)

EXAMPLES

       Read 64 bytes from the EEPROM at address 0x54 on bus 0 starting at address 123 (decimal)

	    eeprog /dev/i2c-0 0x54 -r 123:64

       Print the hex codes of the first 32 bytes read from bus 1 at address 0x22

	    eeprog /dev/i2c-1 0x51 -x -r 0x22:0x20

       Write the current timestamp at address 0x200 of the EEPROM on bus 0 at address 0x33

	    date | eeprog /dev/i2c-0 0x33 -w 0x200

SEE ALSO

       eeprom(8) eepromer(8)

AUTHOR

       Stefano Barbato <stefano@codesink.org>

i2c-tools							     Jul 2013								 eeprog(8)