enum_ieee80211_conf_flags(9) [suse man page]

ENUM 
IEEE80211_CONF_(9) 				  The basic mac80211 driver inte				   ENUM IEEE80211_CONF_(9)

NAME

       enum_ieee80211_conf_flags - configuration flags

SYNOPSIS

       enum ieee80211_conf_flags {
	 IEEE80211_CONF_MONITOR,
	 IEEE80211_CONF_PS,
	 IEEE80211_CONF_IDLE
       };

CONSTANTS

       IEEE80211_CONF_MONITOR
	   there's a monitor interface present -- use this to determine for example whether to calculate timestamps for packets or not, do not use
	   instead of filter flags!

       IEEE80211_CONF_PS
	   Enable 802.11 power save mode (managed mode only). This is the power save mode defined by IEEE 802.11-2007 section 11.2, meaning that
	   the hardware still wakes up for beacons, is able to transmit frames and receive the possible acknowledgment frames. Not to be confused
	   with hardware specific wakeup/sleep states, driver is responsible for that. See the section "Powersave support" for more.

       IEEE80211_CONF_IDLE
	   The device is running, but idle; if the flag is set the driver should be prepared to handle configuration requests but may turn the
	   device off as much as possible. Typically, this flag will be set when an interface is set UP but not associated or scanning, but it can
	   also be unset in that case when monitor interfaces are active.

DESCRIPTION

       Flags to define PHY configuration options

AUTHOR

       Johannes Berg <johannes@sipsolutions.net>
	   Author.

COPYRIGHT

Kernel Hackers Manual 2.6.					     July 2010						   ENUM IEEE80211_CONF_(9)

ENUM 
IEEE80211_KEY_F(9) 				     Advanced driver interface					   ENUM IEEE80211_KEY_F(9)

NAME

       enum_ieee80211_key_flags - key flags

SYNOPSIS

       enum ieee80211_key_flags {
	 IEEE80211_KEY_FLAG_GENERATE_IV,
	 IEEE80211_KEY_FLAG_GENERATE_MMIC,
	 IEEE80211_KEY_FLAG_PAIRWISE,
	 IEEE80211_KEY_FLAG_SW_MGMT_TX,
	 IEEE80211_KEY_FLAG_PUT_IV_SPACE,
	 IEEE80211_KEY_FLAG_RX_MGMT
       };

CONSTANTS

       IEEE80211_KEY_FLAG_GENERATE_IV
	   This flag should be set by the driver to indicate that it requires IV generation for this particular key.

       IEEE80211_KEY_FLAG_GENERATE_MMIC
	   This flag should be set by the driver for a TKIP key if it requires Michael MIC generation in software.

       IEEE80211_KEY_FLAG_PAIRWISE
	   Set by mac80211, this flag indicates that the key is pairwise rather then a shared key.

       IEEE80211_KEY_FLAG_SW_MGMT_TX
	   This flag should be set by the driver for a CCMP key if it requires CCMP encryption of management frames (MFP) to be done in software.

       IEEE80211_KEY_FLAG_PUT_IV_SPACE
	   This flag should be set by the driver if space should be prepared for the IV, but the IV itself should not be generated. Do not set
	   together with IEEE80211_KEY_FLAG_GENERATE_IV on the same key.

       IEEE80211_KEY_FLAG_RX_MGMT
	   This key will be used to decrypt received management frames. The flag can help drivers that have a hardware crypto implementation that
	   doesn't deal with management frames properly by allowing them to not upload the keys to hardware and fall back to software crypto. Note
	   that this flag deals only with RX, if your crypto engine can't deal with TX you can also set the IEEE80211_KEY_FLAG_SW_MGMT_TX flag to
	   encrypt such frames in SW.

DESCRIPTION

       These flags are used for communication about keys between the driver and mac80211, with the flags parameter of struct ieee80211_key_conf.

AUTHOR

       Johannes Berg <johannes@sipsolutions.net>
	   Author.

COPYRIGHT

Kernel Hackers Manual 3.10					     June 2014						   ENUM IEEE80211_KEY_F(9)