9 More Discussions You Might Find Interesting
1. Red Hat
I ran the following command.
cat abc.c > abc.c
I got message the following message from command cat:
cat: abc.c : input file is same as the output file
How the command came to know of the destination file name as the command is sending output to standard file. (3 Replies)
Discussion started by: ravisingh
3 Replies
2. Shell Programming and Scripting
Hi There,
I have a Solaris server that has a bunch of zones configured and I am trying to write a script that will take all interfaces other than the loopback ones (e.g. lo0:3 etc) and present them so that I can easily determine the zone that owns the IP
So in the case of the following... (2 Replies)
Discussion started by: hcclnoodles
2 Replies
3. UNIX for Dummies Questions & Answers
Hi there,
I need your help in understanding the below Solaris 10 ifconfig output;
athnetspns02>ifconfig -a
lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232 index 1
inet 127.0.0.1 netmask ff000000
e1000g0:... (2 Replies)
Discussion started by: wthomas
2 Replies
4. Shell Programming and Scripting
I'm trying to gather information on the interfaces on a large number of servers.
If I run ifconfig I will get: eth0 Link encap:Ethernet HWaddr 00:50:56:A2:27:C1
inet addr:10.145.xxx.xxx Bcast:10.152.45.255 Mask:255.255.254.0
-----
eth1 Link... (2 Replies)
Discussion started by: C0ppert0p
2 Replies
5. UNIX for Dummies Questions & Answers
After running nm command on any object file from out put can we get to know that wheather a symbol is a call to a function or definition of function ?
I am searching a class and function definitions inside many .so files.
I have 3 files which contain the symbol but I don't know wheather they... (2 Replies)
Discussion started by: yatrik007
2 Replies
6. UNIX for Dummies Questions & Answers
Is it possible for both commands to work? (1 Reply)
Discussion started by: phunkypants
1 Replies
7. Shell Programming and Scripting
ok, so I have a script im running on a linux box that uses "egrep" a lot. now, when i run this script, i check the TOP to see how much system resource it is using.
the "top" command gives the following output:
last pid: 25384; load avg: 1.06, 1.04, 0.76; up 351+06:30:24 ... (0 Replies)
Discussion started by: SkySmart
0 Replies
8. IP Networking
I'm running an arp -an on a Solaris 10 box. We're using IPMP. One of the systems is not able to see a host on the same network. The only difference between the two systems (one is having a problem, the other isn't) at least so far is the output of arp:
# arp -an | grep 224.55
e1000g5... (1 Reply)
Discussion started by: BOFH
1 Replies
9. Shell Programming and Scripting
Hello,
I am new to db2 SQL in unix so bear with me while I try to explain the situation. I have a text file that has the contents of the where condition that I am using for a db2 SQL in UNIX ksh.
Here is the snippet.
if ;
then
echo "Begin processing VALUEs"
... (1 Reply)
Discussion started by: jerardfjay
1 Replies