10 More Discussions You Might Find Interesting
1. Red Hat
Hi Guys,
I am not much aware of clusters but i have few questions can someone provide the overview as it would be very helpful for me.
How can i perform cluster failover test to see all the services are failing back to other node ? If it is using veritas cluster then what kind of... (2 Replies)
Discussion started by: munna529
2 Replies
2. Solaris
Hi There,
Just curious here...
If there formula to calculate scan rate on solaris?
Thanks
Edy (3 Replies)
Discussion started by: edydsuranta
3 Replies
3. Solaris
Hi All,
I need suggestions to monitoring Scan Rate on Solaris Operating System.
Any idea?
Thanks
Edy (5 Replies)
Discussion started by: edydsuranta
5 Replies
4. Solaris
Hello experts -
I am planning to install a Sun cluster 4.0 zone cluster fail-over. few basic doubts.
(1) Where should i install the cluster s/w binaries ?. ( global zone or the container zone where i am planning to install the zone fail-over)
(2) Or should i perform the installation on... (0 Replies)
Discussion started by: NVA
0 Replies
5. AIX
Hi Guys,
The management is being frisky about scan rate in the range of a few thousands ( 4 digit scan rates occasionally). After much research ive concluded that its ok to have high scan rates , unless it leads to swapping/ it falls above 1:4 ratio with free rate (fr:sr)
My question is:... (2 Replies)
Discussion started by: muzahed
2 Replies
6. AIX
Hello,
How can i tell ifthe ratio between fr and sr is ok?
is fr/sr ratio of 0.9 acceptable?
thanks. (1 Reply)
Discussion started by: LiorAmitai
1 Replies
7. Gentoo
How to failover the cluster ? GNU/Linux
By which command,
My Linux version
2008 x86_64 x86_64 x86_64 GNU/Linux
What are the prerequisites we need to take while failover ?
if any
Regards (3 Replies)
Discussion started by: sidharthmellam
3 Replies
8. Solaris
Hi,
We have two sun SPARC server in Clustered (Sun Cluster 3.1). For some reason, System 1 failed over to System 2. Where can I find the logs which could tell me the reason for this failover?
Thanks (5 Replies)
Discussion started by: Mack1982
5 Replies
9. HP-UX
I have a 2-node ServiceGuard cluster. One of the cluster packages has a volume group assigned to it. When I fail the package over to the other node, the volume group does not come up automatically on the other node.
I have to manually do a "vgchange -a y vgname" on the node before the package... (5 Replies)
Discussion started by: Wotan31
5 Replies
10. High Performance Computing
I have rcently setup a 4 node cluster running sun cluster 3.2
and I have installed 4 zones on each node. when installing the zones I had to install the zone on all nodes the on the last node do a zlogin -C <zonename>
this worked ok.
theni I tried to siwitch the zone to node a thei work... (14 Replies)
Discussion started by: lesliek
14 Replies