iproxy(1) [debian man page]

iproxy(1)						      General Commands Manual							 iproxy(1)

NAME

       iproxy - proxy that enables tcp service access to iPhone/iPod

SYNOPSIS

       iproxy [LOCAL_TCP_PORT] [DEVICE_TCP_PORT]

DESCRIPTION

       iproxy  allows  you  to	forward localhost ports to the device---allows SSH over USB on jailbroken devices, or allowing access the lockdown
       daemon (and then to all of the file access, sync, notification and backup services running on the device).

       Example :
	./iproxy 2222 22 &
	ssh -p 2222 root@localhost

AUTHORS

       Nikias Bassen <nikias@gmx.li>

       Paul Sladen <libiphone@paul.sladen.org>

       Man page written to conform with Debian by Julien Lavergne.

																	 iproxy(1)

IPHETH(4)						   BSD Kernel Interfaces Manual 						 IPHETH(4)

NAME

     ipheth -- USB Apple iPhone/iPad tethered Ethernet driver

SYNOPSIS

     To load the driver as a module at boot time, place the following line in loader.conf(5):

	   if_ipheth_load="YES"

     Alternatively, to compile this driver into the kernel, place the following lines in your kernel configuration file:

	   device uhci
	   device ohci
	   device usb
	   device ipheth

DESCRIPTION

     The ipheth driver provides support for network access through Apple iPhone and iPad devices, often referred to as USB tethering.

     ipheth should work with any Apple iPhone or iPad device.  In most cases this must be explicitly enabled on the device first.

     For more information on configuring this device, see ifconfig(8).	The device does not support different media types or options.

HARDWARE

     The following devices are supported by the ipheth driver:

     o	 Apple iPhone tethering (all models)
     o	 Apple iPad tethering (all models)

SEE ALSO

     arp(4), cdce(4), intro(4), netintro(4), urndis(4), usb(4), ifconfig(8), usbconfig(8)

HISTORY

     The ipheth device driver first appeared in FreeBSD 8.2.

AUTHORS

     The ipheth driver was written by Hans Petter Selasky <hselasky@FreeBSD.org>.

BUGS

     Some devices may need to be manually configured to use an alternative configuration with the usbconfig(8) utility.  A command similar to
	   usbconfig -u 1 -a 2 set_config 3
     may be required if the device is not recognised automatically by ipheth after it is connected.

BSD
								September 30, 2014							       BSD